Learning to Fly

Why Your Drone Drifts and How to Fix It

Why does your drone drift? Learn the common causes, from wind and weak GPS to calibration and damaged props, and how to fix them on GPS, toy and FPV drones.

On this page
  1. Find out which kind of drift you have
  2. Hovering: the basics
  3. GPS camera drones: positioning and wind
  4. Toy drones: trims and gyro
  5. FPV drones: Acro, Angle and calibration
  6. Mechanical causes
  7. Yaw spin
  8. When to land
  9. Common misconceptions
  10. Safety

Drift means the drone moves when you aren’t moving the sticks. The cause depends on the kind of drone you fly. A GPS camera drone, a toy drone and an FPV quad drift for different reasons, and each needs a different fix. Start by working out which kind of drift you’re seeing.

Find out which kind of drift you have

What you see Likely cause Where to look first
GPS drone slides steadily in a breeze Wind close to or above its rating Wind forecast and the drone’s wind resistance
GPS drone wanders or jumps with little wind Weak positioning, compass or IMU problem GPS lock, compass and IMU calibration, vision sensors
Toy drone drifts one way with sticks centered Trim or gyro out of level Trim buttons, gyro re-level
Drone leans or drifts, especially after a crash Bent motor shaft, cracked prop, loose screws Physical inspection of props, motors and arms
FPV quad drifts in Angle or Horizon mode Accelerometer or gyro calibration Calibrate on a level surface
FPV quad drifts in Acro mode Expected, because Acro doesn’t self-level Keep correcting; practice the sticks
FPV quad spins around its yaw axis Prop or motor direction, damaged motor Check each prop and motor

Hovering: the basics

A question many new pilots ask is how to make a drone hover. The answer depends on the drone.

On a GPS camera drone, let go of both sticks. The sticks spring back to center, and the drone holds its position if the GPS and sensors are working well. If it drifts while you’re hovering, check the GPS lock first.

On a toy drone or an FPV quad, there is no position hold. Hold the throttle near the hover point and make small corrections. Practice in calm air first, and keep the drone at a height where you can judge its movement.

GPS camera drones: positioning and wind

A GPS camera drone uses satellite positioning (GNSS) to hold its place. Near the ground, it also uses downward vision sensors. Both can fail. Vision positioning struggles over water, glossy floors, plain surfaces and in low light. When it does, the drone can drop into a drifting, attitude-style mode and stop holding its position.

Fixes to try, in order:

  • Calibrate the IMU on a level surface when the app asks. Keep the drone still while it calibrates.
  • Calibrate the compass away from metal, vehicles and reinforced concrete, and only when prompted. The pre-flight checklist covers when calibration is needed before a flight, and the DJI compass calibration guide walks through the steps.
  • Recalibrate the remote sticks in DJI Fly if the sticks don’t return to center. If the problem continues after calibration, the stick gimbals may be worn and need replacing.
  • Check the wind. Compare gusts with the drone’s rated wind resistance. Calibration can’t fix wind that is beyond the drone’s limits, so land or wait for calmer air.

Toy drones: trims and gyro

Toy drones usually have no GPS, so their drift comes from the gyro and from trim. Use the trim buttons to cancel a steady drift, and make adjustments in small steps. Re-level the gyro if the drone drifts with the sticks centered. On many toy drones this is done by holding both sticks to a corner, but the method varies by model, so check the manual.

If a toy drone’s drift changes after a crash, check the props and motors before you trim it again.

FPV drones: Acro, Angle and calibration

FPV means first-person view, where you fly from a camera feed on goggles or a screen. An FPV quad’s behavior depends on its flight mode.

  • Acro (rate) mode has no self-leveling by design. The craft drifts unless the pilot corrects it constantly. This is expected behavior, not a fault.
  • Angle or Horizon mode does level the craft. If it drifts in these modes, calibrate the accelerometer in Betaflight on a level surface, and adjust the accelerometer trims if needed.

Betaflight calibrates the gyro at power-up, so keep the quad still and level when you plug it in. In Betaflight’s Receiver tab, centered sticks should read close to 1500 µs, with the endpoints around 1000 and 2000 µs. Adjust the centering on the radio, or set a small deadband if the sticks don’t center exactly.

Avoid using trim to fix drift on modern Betaflight builds. Calibrating is the better fix, and trim can hide a real problem.

Mechanical causes

Physical damage causes a lot of drift that calibration can’t fix. Look for:

  • a bent motor shaft (see how long drone motors last)
  • a chipped or cracked prop
  • loose motor screws
  • frame flex or a cracked arm
  • a battery mounted off-center, which shifts the drone’s center of gravity

Check these before you change any settings. Remove the props before you spin motors by hand or do any bench testing. After a crash, check the props, motors and arms first.

Yaw spin

If the drone spins around its vertical axis, look at the props and motors. A prop fitted in the wrong direction, a motor wired the wrong way, or a damaged motor can all cause spin. Check each prop’s direction against its motor before you adjust yaw settings.

When to land

Land immediately if the drift gets worse, or if you can’t keep the drone in one place. Don’t fly over water with unreliable positioning, because a drone that drifts over water is hard to recover.

If the drift only happens indoors, the cause is usually vision positioning. Flying indoors explains how to set up a room so the drone can hold its position.

Common misconceptions

  • “Any drift means a broken drone.” Wind and weak positioning are the most common causes.
  • “Compass calibration fixes every drift.” The IMU, sticks and props are often the real cause.
  • “Acro drift is a tuning bug.” Acro has no self-leveling by design.
  • “Trim fixes FPV drift.” On modern Betaflight builds, calibrate instead.

Safety

Remove the props before any bench testing, calibration or motor checks. Land straight away if the drift is getting worse. Keep the drone away from people while you investigate.

The complete guide to learning to fly

How to Fly a Drone: Controls and Basic Movements
Read the guide

Keep exploring

Guides from other topics

All topics →