Learning to Fly

Drone Pre-Flight Checklist for Your First Flight

A pre-flight checklist for your first drone flight: charging and updates, registration, airspace and weather checks, inspection and a short first hover.

On this page
  1. At home, before you leave
  2. Registration and rules (US)
  3. Check airspace and weather
  4. At the flying spot
  5. Power on and check the app
  6. The first flight
  7. Quick checklist
  8. Common misconceptions
  9. Safety

A first flight goes best when you treat the checklist as a routine rather than a memory test. Run it at home, again before you leave the car, and again at the flying spot. The steps below assume a consumer camera drone, such as the DJI Air 3 at about 720 grams, but the same logic applies to most models.

At home, before you leave

  • Charge everything. That means every drone battery, the remote, and your phone or tablet. Carry a spare battery if you have one (how many batteries you need).
  • Update firmware and the app. DJI Fly prompts you when a firmware update is available. Install it before you leave, not in the field. See how to update DJI firmware safely.
  • Activate the drone. DJI drones must be activated in DJI Fly on first use, with an internet connection on your phone.
  • Format the microSD card. Format it in the drone’s settings, and check that it has enough free space for your footage.
  • Pack the basics. Bring spare propellers, a small screwdriver and the gimbal protector you’ll need to remove before power-on.

Registration and rules (US)

For recreational flying in the US, drones weighing 250 grams (0.55 pounds) or more must be registered with the FAA. An Air 3 at about 720 grams needs registration. Mark the registration number on the outside of the drone. Recreational pilots also need the free TRUST certificate, which does not expire. Our FAA DroneZone guide explains how to register and what the fees are. Rules differ in other countries, so check your local authority first. Flying a drone abroad covers the main ones.

Check airspace and weather

  • Check airspace. Use an FAA-approved app. The FAA’s B4UFLY app and apps such as Aloft show airspace. In controlled airspace, you may need LAANC authorization before you fly. Where you can fly a drone explains the airspace classes.
  • Check for temporary flight restrictions (TFRs). These can appear at short notice, so check again on the day.
  • Check the forecast. Don’t fly in rain. Keep wind well below the drone’s rated wind resistance, and avoid gusty days. Flying in the rain explains why.

At the flying spot

  • Choose a flat, clear spot. Stand at least about 5 meters (16 feet) from people while you take off and land.
  • Inspect the props. Look for chips, cracks or bends. Check that each prop matches its motor. Marked props go on the marked motors.
  • Remove the gimbal protector. Do this before you power on, and check that the gimbal moves freely.
  • Check the lens. Wipe away dust or moisture so the footage starts clean.

Power on and check the app

  • Power on the remote first, then the drone. This is the standard order for DJI drones.
  • Wait for GPS lock. Don’t take off until the app shows a solid GPS lock and the “Home Point Updated” message.
  • Set the return-to-home (RTH) altitude above the tallest obstacle. The default may be too low near trees or buildings. Set it higher if you need to.
  • Check the failsafe action. RTH is the usual default on DJI drones. What to do if your drone loses signal covers the other options.
  • Calibrate the compass only when the app asks. Calibrate away from cars, metal and reinforced concrete. How to calibrate a DJI drone compass has the steps.

The first flight

Take off and hover at about 2 to 3 meters (roughly 6 to 10 feet) for 30 to 60 seconds. During the hover, check that:

  • the drone holds its position without much input from you
  • it responds smoothly to small stick movements
  • the video feed is steady and the props sound normal

Then make short, slow moves in each direction and return to the spot. If anything looks or sounds wrong, land and check the drone before you fly again.

Land when the battery reaches 20 to 30 percent. Cold weather drains batteries faster, so land a little earlier in the cold.

Quick checklist

  • Batteries charged: drone, remote, phone or tablet
  • Firmware and app updated; drone activated in DJI Fly
  • microSD card formatted with free space
  • Drone registered and the number marked on the outside (US, 250 g and up)
  • TRUST certificate completed (US recreational)
  • Airspace checked in an FAA-approved app; no TFRs
  • Weather suitable: no rain, wind well below the rating
  • Props inspected and fitted to the right motors
  • Gimbal protector removed; lens clean
  • Remote on first, then the drone
  • GPS lock and home point updated
  • RTH altitude set above obstacles
  • Short hover completed before the first real flight

Common misconceptions

  • “Calibrate the compass before every flight.” Only when the app asks, or after moving the drone a long way.
  • “Registration only applies to commercial pilots.” Recreational drones of 250 grams or more also need it in the US.
  • “Obstacle sensing makes the RTH altitude irrelevant.” Set it above obstacles anyway.
  • “Taking off from a car roof or metal table is fine.” Metal can corrupt compass readings.

Safety

  • Take off from a flat, clear spot, with people at least about 5 meters away.
  • Land with 20 to 30 percent battery remaining.
  • Don’t fly with cracked props or a swollen battery.

The complete guide to learning to fly

How to Fly a Drone: Controls and Basic Movements
Read the guide

Keep exploring

Guides from other topics

All topics →