Most consumer drones shouldn’t fly in rain. Their motors, electronics and batteries usually aren’t sealed against water, and rain brings wind, poor visibility and wet sensors. Some industrial drones carry water-protection ratings, but a rating doesn’t make rain flying safe.
Why water is a problem
Most consumer drones, including DJI’s Mini, Air, Mavic and Avata models, have no IP rating. Water can get into the motors, the electronics and the flight controller.
Brushless motors are open to the air so they can cool, which also lets water and grit in. Water on circuit boards can short electronics, and the damage may not show up until days later as corrosion. Even light drizzle adds moisture each time, and that moisture adds up.
Wet sensors and lenses
Drones rely on their sensors to avoid obstacles and hold position. Water droplets on those sensors can cause obstacle-sensing and positioning errors. Water on the camera lens ruins footage, and it can be hard to notice until you review the clips.
Condensation is a related problem. Moving a cold drone into a warm room, or flying in heavy fog or humidity, can leave moisture inside. Let the drone warm up gradually, and check for condensation before powering on.
Rain comes with wind and low visibility
Rain usually comes with gusty wind. Gusts can push a drone off course and toward obstacles, and they drain the battery faster. Rain and low cloud also reduce visibility, which makes it harder to keep the drone in sight.
Cold rain or sleet can ice the propellers and reduce lift. Cold also drains batteries faster. See drones for cold weather and snow.
For a benchmark, US commercial rules (Part 107) set weather minimums of 3 statute miles of visibility, and cloud clearance of 500 feet below and 2,000 feet horizontally. Recreational pilots aren’t bound by those exact numbers, but they are a useful guide for deciding whether to fly at all.
What IP ratings mean
An IP rating has two digits. The first describes protection against solid particles such as dust. The second describes protection against water.
- IP55 protects against low-pressure water jets. It isn’t a submersion rating.
- IP67 protects against short immersion, up to about 1 meter.
A water-resistant drone isn’t a waterproof one, and a rating doesn’t mean the drone is safe to fly in rain. Wind-driven rain also tests a drone harder than a lab test does. Treat an IP rating as extra protection, not as permission to fly in wet weather.
Warranty and water damage
DJI’s standard warranty doesn’t cover water damage. DJI Care Refresh may cover water damage as accidental damage, but the terms vary by plan, so check your plan before you rely on it.
If your drone gets wet
- Power the drone off and remove the battery.
- Air-dry it at room temperature for 24 to 48 hours before you power it on again. Don’t put it in rice, which can leave dust inside. Air drying works just as well.
- Don’t charge or fly a battery that got wet. Lithium polymer cells can fail dangerously.
- If you’re not sure the drone is dry, or it behaves oddly after drying, get it checked before you fly again.
Common misconceptions
- “Light drizzle is harmless.” Moisture adds up, and it can corrode electronics over time.
- “Rice dries electronics.” Air drying is as effective, and rice dust can get inside the drone.
- “Water-resistant means waterproof.” Splash and jet ratings aren’t submersion ratings.
- “Props flick the water off, so it’s fine.” Spray still reaches the motors and vents.
Safety
- Don’t charge or fly a battery that got wet.
- Land straight away if rain starts during a flight. Landing safely covers how to bring the drone down in windy or unsettled conditions.
- Check the forecast before every flight, and use the pre-flight checklist to confirm the weather.